Morphy Richards 73281 Accessing the floor nozzle, Refitting the floor nozzle cover, Helpline

73281 rev1 13/3/08 16:22 Page 7

Accessing the floor nozzle

1Disconnect the cleaner from the mains supply.

2Press the handle release pedal and place the cleaner face down on a soft surface, eg. carpet.

3Remove the four screws holding the two undercarriage plates ö in position. Remove the plates P.

4Lift up the undercarriage ÷ and unclip from it’s location Q.

5Underneath the undercarriage is the height adjustment cam. In the centre of the cam is a screw, remove this screw R.

6Next, remove the four remaining floor nozzle screws ø, two located by the rear wheels and two halfway along the floor nozzle S.

7Turn the product over and pull off the height adjustment knob.

8Lift the rear of the floor nozzle cover and unclip from the front. Put safely to one side T.

Refitting the floor nozzle cover

1Hook the front of the cover into the floor nozzle, then lower the rear of the cover. Note: it may be necessary to lift the upright portion of the product to allow the cover to fully close.

2Refit the four main screws.

3Turn the product over and check that the front of the cover is fully closed.

4Insert the height adjustment knob, carefully turning it until it locates into the mating keyway on the cam.

5Turn the product back over and locate the screw into the centre of the cam and tighten.

6Clip the undercarriage into location and close into position.

7Re-fit the two undercarriage plates and tighten the four screws.

Return the cleaner to the upright position. Connect to the mains supply and switch on to test.

N

ñ

O

ò

ó

P

ö

Q

÷

R

Removing and re-fitting the rotating brush bar & belt

1Lift out the belt cover ù U.

2Gently lever out the right hand side of the brush-bar, followed by the left hand side V.

3To re-fit, thread the brush-bar through the belt. Place the left hand side of the brush-bar into location, then place the belt around the motor shaft. Pull the brush-bar forwards (stretching the belt) and locate the right hand side of the brush-bar.

4IMPORTANT: Make sure both ends of the brush-bar are fully and correctly located, and the belt is not trapped. The brush-bar should be able to be rotated by hand.

5Re-fit the belt cover carefully, noting it’s location.

7

HELPLINE

If you have any difficulty with your appliance, do not hesitate to call us.

We are more likely to be able to help than the store from where you bought it.

Please have the following information ready to enable our staff to deal with your query quickly.

•Name of the product

•Model number as shown on the rear of the appliance.

•Serial number as shown on the rating label.

UK Helpline	0844 871 0949
Replacement Parts	0844 873 0715
Ireland Helpline	1800 409 119

www.morphyrichards.com

S

ø

ø

T

U

ù

V

ô õ

7