Morphy Richards 73281 Using on carpets, Using the attachments, Using & cleaning the turbo nozzle

73281 rev1 13/3/08 16:22 Page 5

Using on carpets

1Place the cleaner in it’s upright position.

2Set the carpet height adjustment dial á to the desired position.

3Release the mains cable by revolving the quick release cleat half-a-turn and extend the cable fully.

4Plug the cable into the mains socket.

5Step on the handle release pedal to release the handle to the desired position.

6Press the ON/OFF button to the ‘ON’ position.

IMPORTANT: To prevent damage to carpets:

•Never leave the cleaner switched on in one place for an extended period.

•Never have the brushes set too low such that the cleaner is hard to push.

•Never lean on the product.

Using the attachments

Follow steps 1-4 of the ‘Using on carpets’ section, but set the carpet height adjustment dial to the tools setting.

5Attach the accessories â ã ä to the handle, removing the handle from the telescopic tube, then firmly push in the desired accessory F:

Turbo tool â is ideal for pet hair removal from stairs and upholstery.

Upholstery tool ã for upholstery, stairs etc.

Dusting brush ã for delicate surfaces.

Crevice tool ä for awkward places, corners and behind radiators etc.

6	If additional length is required,	F
	remove the telescopic tube from
	the cleaner, connect it to the
	handle, and add the desired
	accessory to the end of the tube
	G.
7	Switch ON/OFF.

•IMPORTANT: When using the hose and tools, locate the hose into the hose hook ì on the main unit. This will help prevent the cleaner from tipping over.

•IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretched hose.

Using & cleaning the turbo nozzle

Attach the Turbo nozzle to either the handle or the telescopic tube as described previously.

Following use, your turbo nozzle may become clogged. Switch the cleaner to ‘OFF’. Turn over the tool and pull away any hairs or fibres. If they are tightly wound around the brush, carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose.

SAFETY CUT-OUT

If the cleaner overheats, a motor protection thermostat will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 60 minutes. Check the airways for blockages, empty the dust canister and clean the filters before restarting.

G

www.morphyrichards.com
	5