70223 Rev 2 9/8/04 4:00 PM Page 10
Shampooing instructions
Features
In addition to the components previously mentioned under the ‘Wet & Dry’ section, the following will be used when shampooing:
Foam filter E2
ÒFoam filter locking plate E2 Ù Clean water tank
ı Filler cap ˆ Filter
˜ Feed pipe
¯ Cleaning solution ˘ Water inlet
33 Shampoo tube
34 Shampoo Nozzle
35 Tube connector
36 Shampoo jet
37 Upholstery shampoo nozzle
Assembly
For best results, carpets to be shampooed should be vacuumed first using the standard floor nozzle.
After following the assembly instructions in the wet and dry section, remove the filler cap from the clean water tank and add up to
3.5litres of water. Warm water may be used, but never hot. Add cleaning solution to the water following instructions on the bottle J.
Replace the filler cap ensuring the filter is on the end of the feed pipe (using without the filter may damage your machine and invalidate the guarantee). Fit the clean water tank into the tool storage cart. Push the nozzle on the other end of the feed pipe into the water inlet K.
Ensure the bucket is fitted inside the waste tank. It is possible to shampoo without using the bucket although it is far simpler to empty dirty water when the bucket is used. Fit the hose end into the waste tank after the bucket has been installed.
Remove the cartridge filter from underneath the motor housing (see ‘Cartridge Filter’ in the Wet & Dry section). Fit the foam filter in its place.
IMPORTANT: The foam filter must always be fitted when you are shampooing.
The filter should be pushed up against the base of the motor housing and secured by use of the foam filter locking plate. The locking plate is inserted beneath the foam filter and rotated clockwise until it locks into position E2. Refit the motor housing.
Slide the coiled shampoo tube and hose and extend to full length. L. Fit one end of the shampoo tube into the main housing connector 35 and the other end into the shampoo nozzle jet 36 .
Controls
To shampoo press the rocker switch to the II position, the pump will be activated and water and cleaning solution will be forced down the shampoo tube.
IMPORTANT: Do not switch the pump on when there is no water in the clean water tank - this will damage the pump.
10