70223 Rev 2 9/8/04 4:00 PM Page 14
Storage
Prior to storage the following steps should be taken:
1Empty the bucket and reassemble as described under ‘Emptying’.
2Remove the shampoo nozzle and, using the end of the extension tube, suck up some clean water so that the inside of the tubes and hose are cleaned.
3Empty the bucket once more and wipe clean.
4Remove the foam filter and rinse under a tap. Either refit the foam filter or, if the
cleaner is to be used next for dry pick up, refit the cartridge filter.
5Empty any solution remaining in the clean water tank. This may then either be re- fitted into the tool storage cart, or stored elsewhere so that tools may be stored in the cart.
How to get the best from your shampoo system
•Always use AquaVac or Goblin cleaning solution. This contains the right amount of cleaner and defoamer.
•Only fill the clean water tank as directed.
•Do not over wet the area being cleaned. If this occurs pass over with suction only.
•Do not walk on carpets or replace furniture until fully dry.
•Clean out the tanks, bucket, hose and extension tubes after use.
•Do not leave solution inside the tank when not in use.
•Never use a cleaning solution without a defoaming agent included.
•The transparent shampoo nozzle can be cleaned by removing the four screws so that it can be taken apart. Wipe with a damp cloth. When
•If water and cleaning solution fails to come out of the shampoo nozzle, check the following:
-is the rocker switch in the correct position?
-is the clean water tank empty?
-is the feed pipe connected to the water inlet?
-is the tube connector attached to the shampoo jet?
-is the correct shampoo being used?
Helpline
If you have any difficulty with your appliance, do not hesitate to call us. We’re more likely able to help than the store from where you bought it.
Please have the following information ready to enable our staff to deal with your query quickly:
•Name of the product
•Model number as shown on the underside of the motor housing (inside the tank).
14