70223 Rev 2 9/8/04 4:00 PM Page 4
Wet & dry vacuuming usage
Features | Assembly | |
⁄ Waste tank | 1 | Release the tank latches and lift off the |
¤ Motor housing |
| motor housing as shown D. |
‹ Power switch | 2 | Remove any parts stored for transit inside |
› Tank latches |
| the tank. |
fi Castors | 3 | Turn the tank upside down. To fit the |
fl Inlet |
| wheels, slot a bolt through the centre of a |
‡ Hose end |
| wheel, push the bolt into the hole on the |
· Carrying handle |
| side of the cart and secure by inserting a |
‚ Hose |
| screw B1. |
„ Curved handle | 4 | Now fit a hub cap B1. Do the same for |
‰ Extension tubes |
| the other wheel. |
 Floor nozzle | 5 | Push the 2 castors into the holes and |
Ê Bolt |
| press firmly B2. |
Á Screw | 6 | Refit the motor housing ensuring that the |
Ë Wheel |
| switch is positioned above the inlet as |
È Hub cap |
| illustration A. If the motor housing is |
Í Exhaust filter flap |
| fitted in any other position the latches will |
Î Cable storage hook |
| not lock. |
Ï Cardboard collar (on paper bag) | • | Press the middle and not the bottom of |
Ì Tool storage cart |
| the latch to lock. |
Ó Cartridge filter | 7 | Assemble hose, extension tubes and |
Ô Bucket |
| nozzles as required, see A. Insert the |
Foam filter |
| hose end into the tank inlet and twist to |
Ò Foam filter locking plate |
| secure. |
Ú Crevice tool |
|
|
Û Upholstery tool |
|
|
4
