43550 Filter kettle Rev 5 21/3/05 3:03 PM Page 4
Using
Filtering your water improves the taste and appearance of beverages by reducing limescale, lead, chlorine and other impurities.
Before use
1Remove cartridge from the packet, place in a bowl of water and shake.
2Take the top compartment (the cartridge holder) out of the kettle by pulling the cartridge holder easy release button Ë forward and lift upwards. A
3Ensure the filter seal is in place. B
4 Insert the cartridge into the top compartment from the bottom and twist clockwise to lock in place. C
5 Replace the cartridge holder back into the kettle and click into place.
Filling the kettle
1Fill the kettle with tap water to the maximum mark either by lifting up the lid D or by sliding the filler slider to one side as shown. E
2Allow water to filter through system. When using for the first time discard the water and repeat once more.
The amount of water must cover
the kettle element. The minimum is 1 cup or 30 cls. Do not fill above the maximum mark or filter performance will be impaired. Always ensure the kettle is emptied before refilling.
Electronic cartridge reminder
Certain models only
After changing the cartridge and for first usage, the counter must be reset.
1Hold the start button for 3 seconds (100% will show on the display and the outer ring will flash). F The display will then switch off due to its energy saving device after 3 minutes.
2You can check the progress of your cartridge at any time by pressing the start button for 1 second. The counter will count down from 100% to 25%.
325% turns off when the cartridge needs
replacing. The outer ring of the display will flash and continue to flash until the cartridge has been changed. G
4Reset the reminder as per point 1.
A
C
B
D
E
G
F
4
