Morphy Richards KT43922 manual Operating, Appliance, Before USE, Hints and Tips

43922 rev2:x 06/01/2010 15:06 Page 4

	OPERATING THE	7 If you find the cup is		3	Set cup size selector › to
	APPLIANCE		getting too full, or you have		maximum and place
	BEFORE USE		not placed your cup in		suitable vessel under the
			position, the excess water		spout.
			will overflow into the drip	4
	Before using your Meno		tray. Alternatively, press the		Press the start button fl
	One Cup for the first time		stop button. fi		and allow the unit to run
	or if you have not used it				and dispense the full
	for some time, rinse the		Ensure you empty the drip		volume of water.
	machine by running some		tray after every use when	5
	water through the machine.		cooled by removing from		Repeat steps 3 and 4.
	Follow the making a drink		the bottom of the unit.	6
	instructions and dispose of	8 When dispensed, the			Allow unit to stand for 10
	the hot water.				minutes.
			illumination will go off and	7
	Making a drink		the unit will make a gulping		Press the start button fl
			noise which is normal.		and allow the unit to run
1 To fill the water tank, lift the		9 If you require another cup			and dispense the full
					volume of water.
	handle ‹ to the upright		afterwards, ensure enough	8
	position and carry to a tap		water is in the tank, and		Repeat step 7 until the tank
	to fill or by pouring water in		press the start button again		is empty.
	from a jug in position. The		to begin.	9
	water tank flap will open				Tip unit upside down over a
	automatically when the		If you want to empty the		sink and shake to remove
	handle is raised.		water from the unit, take off		any water left in the boiling
			the base and use the		chamber Â.
	Once you have the required		handle to carry to the sink	10
	level of water and the unit		and empty.		Fill the water reservoir to
	is back on the base „				maximum level with cold
	securely, place the handle		When you think it is empty,		water.
	down. This will close the		shake to ensure all the	11
	flap.		water has been dispensed.		Set cup size selector to
2 Ensure that the drip tray is					maximum and place
			Descaling		suitable vessel under the
	attached by sliding it into				spout.
	place. ‚

3Adjust the cup size selector › to the correct size for your cup, left being a small cup (150ml), right being a large cup (maximum

dispense at one time is 300ml). ›

4Place a cup to hold the hot

water on the drip tray below the spout. ‡

5Press the start button fl. The unit will become illuminated and will begin to heat and dispense the required amount of water.

6If the unit does not start boiling, check the base is connected correctly.

IMPORTANT: As this appliance is fitted with a concealed element it must be descaled regularly. The frequency of descaling depends on usage and the hardness of the water in your area.

Excessive scale can cause the appliance to switch off before boiling and may damage the element invalidating the warranty.

It is essential that regular descaling takes place.

1Fill the water reservoir to maximum level with cold water.

2Add one sachet of proprietary liquid descaler, which is suitable for plastic kettles.

12Repeat steps 7-10.

13Continue to use as normal.

IMPORTANT: Ensure that the electrical connections are completely dry before using the appliance.

HINTS AND TIPS

Cleaning and maintenance

WARNING: Always disconnect the plug from the mains and allow the appliance to cool before cleaning.

Wipe the outside with a damp cloth.

IMPORTANT: Do not use abrasive cleaners on the outside of the appliance which may scratch the surface.

4 UK Helpline 0844 871 0954 Replacement Parts 0844 873 0720 Ireland Helpline 1800 409 119 4