Fig 5

Fig 6

Step 4

Using a ruler or tape measure, draw a line on each piece of tape parallel to each first line at a distance of 3/8” (9.5mm) from each first line. (See Fig 5)

Step 5

You are now ready to begin tensioning the belt. Before beginning, make sure the line on each piece of tape closest to the tail roller is aligned with the edge of the deck on each side. (See Fig 5)

Step 6

Using the 1/4" Allen wrench begin tightening the tensioning screws (see Fig 1). You will tighten (or stretch) the run belt until the forward lines on the tape are aligned with the edge of the deck.

Be careful to ensure the Tail Roller does not turn while you are stretching the belt. If the Tail Roller turns while you are stretching the belt, start the procedure over. If the Tail Roller turns while stretching the belt you will not obtain proper tension.

When finished, remove the tape from the running belt.

53

Service Manual: E-TR and E-TRi

Page 55
Image 55
Star Trac 7700, 7600 manual When finished, remove the tape from the running belt