
MAINTENANCE MODE – TEST MODES
Within the Maintenance Mode parameters are a few Test Modes that can be used to test various functions of the unit. While in the Maintenance Mode, set the following parameter and use the functions as listed to utilize each parameter.
DISPLAY TEST
The Display Test can be used to test each individual key for function and response, and can also be used to verify led function and display.
Press ‘Start’ key | Display will enter DISPLAY TEST and await your next command | ||
Press ‘Start’ key | Display will cycle thru a self test and display all led’s in a sequenced pattern | ||
Press ‘Stop’ key twice to return to the MAINTENANCE MODE | |||
|
|
| |
Press ‘Start’ key | Display will enter DISPLAY TEST and await your next command | ||
Press ‘1’ key | MC1 Vx.x CKSM xxxx will display |
| Loop |
Press ‘Speed Plus’ key | MC2 Vx.x CKSM xxxx will display |
| |
Press ‘Speed Minus’ key | MC1 Vx.x CKSM xxxx will display |
|
|
Press ‘Stop’ key twice to return to the MAINTENANCE | MODE | ||
|
| ||
Press ‘Start’ key | Display will enter DISPLAY TEST and await your next command | ||
Press ‘2’ key | Display will read KEYBOARD TEST |
|
|
| Press any key except ‘Stop’ to verify function. |
Press ‘Stop’ key to verify function then press again to return to the MAINTENANCE MODE
Note: You can also access the Display Test right away when entering the Maintenance Mode: When the display reads UNITS: ENGLISH (or UNITS: METRIC),
press the ‘5’ key then follow the procedures above.
MOTOR TEST
This parameter is used by Star Trac at the factory.
*For MOTOR TEST MODE, see the MOTOR TEST MODE section of this manual.
BELT/DECK TEST
This parameter is used by Star Trac at the factory.
31 | Service Manual: |