Fig 3
Fig 4
Fig 5
6.Unplug JP1 and move it up one pin so it is now connected to the top two pins and the bottom pin is exposed (see Fig 3).
7.Unplug JP2 and move it down one pin so it is now connected to the bottom two pins and the top pin is exposed (see Fig 3).
Jumpers in PROGRAM mode
8.Plug the uploader cables to the uploader box:
Plug the power cable into the uploader inserting the small pin connector into the small hole.
Plug the RS232 cable (flat ribbon cable) into the uploader taking note of the index key in the connector and the plug.
9.Plug the RS232 cable to the RS232 pins on the mcb with the RED wire facing down (see Fig 4).
10.Plug the power cord to the display cable plug on the mcb (see Fig 5).
47 | Service Manual: |
