47570 Rev 1 25/6/04 4:57 PM Page 4
Before first use
Before using your coffee maker for the first time or if you have not used it for some time, rinse the machine by running water through. Follow the procedure for making espresso coffee below, without coffee in the filter holder.
Espresso operation
Filling the water tank
1Open the water tank Á by sliding the tank sideways using the ribs and remove to fill. A
IMPORTANT: Do not overfill or carry when full.
A |
WARNING: Do not fill through the top lid, only fill the tank itself.
2Fill the water tank Á using cold tap water. B
3Replace the water tank by sliding it back into place. C
BC
IMPORTANT: Ensure the tank is pushed firmly into place or the water will not flow.
Operating your coffee maker
1Plug the unit into the power outlet.
2Switch the unit on by pressing the on/off switch fi. The ‘power light’ ‹ and ‘warm up light’ ¤ will illuminate.
3Select the filter ‚ and place in the filter holder ‡. D
DE
4Using your measuring spoon „ supplied, measure 1 spoon for one cup and 2 spoons for 2 cups of ground coffee into the filter. With the other end of the measuring spoon, use the compactor ‰ to tamp down the
coffee. E
IMPORTANT: Be sure not to overfill the filter with too much coffee, and wipe around the edge of the filter to remove any coffee grounds.
5Place the filter holder ‡ on the brewing head and position the handle so it points to the left. F
Ensure the filter holder is flat against the brewing head and turn the handle towards the right G as far as it will go. Note: Do not overtighten.
FG
•Hint - The spoon can be stored in the drawer Í after use.
4