Morphy Richards Reflect glass kettle manual Using, Filter removal

Using

1Wherever possible fill through the spout, as this helps to free the filter from limescale build-up.

The kettle can also be filled through the

lid. Use the lid release button ¤ to open.

•The clear glass body of the kettle allows you to easily see the amount of water in the kettle.

•IMPORTANT : When filling from a tap, care must be taken to avoid striking the glass body on the tap.

•Always ensure that the level of water in the kettle is filled to at least the minimum level shown on the water level indicator.

•Boil only as much water as you need as

this saves electricity.

2Place the kettle on the base unit, ensuring the kettle locates on to the

360˚ connector.

•The 360˚ connector allows the kettle to be located at any position. - ideal for left and right handed users and for

convenient positioning on worktop.

3Plug in and switch on at the wall socket.

4Switch the kettle on. The ‘power on’ neon, will light up.

5When the water boils the kettle will switch off automatically.

•If you are using the kettle for the first time, pour away the boiled water and refill.

6Lift the kettle from the base unit by the handle ensuring you hold the kettle level.

•To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again.

•If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal.

Filter removal

1Open the lid using the release button ¤.

2Lift the filter upwards to remove.

3To refit the filter, slide it into the side guides of the filter holder until it clicks into place. Ensure the filter is correctly located.

WARNING: Unless the filter is fitted correctly, the kettle lid may not close and the kettle may not switch off after boiling.

4