73320 Rev 3 17/1/05 2:38 PM Page 4
Assembly B
WARNING: Do not plug in the cleaner until it is assembled.
1Carefully unpack all components.
2Lift cleaner body to upright position.
3Remove the two screws that are already attached to the body.
4From the rear of the cleaner, align the handle with groove and slide into the
body. If necessary, use thumb and finger pressure to slide handle into position.
5Fasten the handle with the two screws.
Floor nozzle height adjustment C
Before using the cleaner the floor nozzle height must be set to the correct height.
Choose the setting which most closely matches your floor surface.
•Use the DEEP CARPET setting when using the tools.
Note: The height adjustment only comes
into effect when the handle is released by the handle release pedal È.
Variable power D
(Certain models only)
Slide the variable power control to the right to increase the suction power or to the left to decrease suction. This feature is most useful when using the hose and accessories. Use the minimum setting when vacuuming delicate fabrics/curtains etc. When not using the hose it is advisable to keep the variable slider set to maximum.
Using on carpets
1Place cleaner in its upright position.
2Set the carpet height adjustment knob to the desired position.
3Release the mains cable by revolving the
quick release cleat 1/2 a turn and extend the cable fully.
4Plug the cable into the mains socket.
5 Step on the handle release pedal to release the handle to the desired position.
6 Press the on/off button to the ‘on’ position.
IMPORTANT: To prevent damage to carpets, never leave the cleaner switched on in one place for an extended period.
• Never have the brushes set too low such that the cleaner is hard to push.
B
C
DEEP CARPET | HARD FLOOR |
TOOLS
MEDIUM CARPET
D
min
max
4
