Mosquito Magnet Defender Assembly/Starting Instructions, Trap Placement, turning counterclockwise

ASSEMBLY/STARTING INSTRUCTIONS

9	Plug power connector into
	the Defender unit power
	slot located on the back of
	the power head.

10	Plug adaptor into properly
	grounded electrical outlet.
	This adaptor is not intended
	to be mounted. For UL Listed
	trap use 120 Vac adaptor.
	For CE marked trap use 230
	Vac adaptor.

11	Turn propane on by slowly
	turning counterclockwise.
	Take care not to turn too
	quickly to avoid engage-
	ment of safety check valve
	in regulator.

CONTINUE

TO STARTING

INSTRUCTIONS.

9

TRAP PLACEMENT
1	Determine the direction of the prevailing wind.
2	Stand in the center of the area you are trying to protect and look toward the prevailing wind. Proper
	placement of the Mosquito Magnet will be 30-40 feet in front of you, within 5-6 feet of ground cover
	(i.e., bushes, flowerbeds, treeline, marshbed, etc.)
3	It is recommended that the trap be placed in the shade.
4	Do not place trap directly above water source (sprinklers, hose, etc.).
5	Make sure unit is not directly up against a blockade such as a building or fence.
6	Trap must be placed on level ground to avoid tipping or uneven propane distribution.
7	For more information, refer to trap placement section of our website at www.mosquitomagnet.com.

STARTING INSTRUCTIONS

It is recommended that you read the entire manual before starting the Mosquito Magnet Defender

1	Connect regulator to propane tank.
2	Plug power connector into the trap.
3	Plug AC adapter into electrical socket. To avoid the risk of electrical shock, connect only to properly
	grounded outlets. Adaptor unit is not intended to be mounted.
4	Slowly turn propane tank on (turn valve counter clockwise).
5	Turn rocker switch to “on” position.
6	The red light on the switch will flash for up to 20 minutes (warm up phase).
7	Once the light stops flashing and is solid the Mosquito Magnet is fully operational.

10