Motion Computing FWS-DS1 warranty English

English

This document contains regulatory, precautionary, and recycling information for the Motion CL-Series Docking Station Model FWS-DS1. To avoid injury, read this document and understand its contents before you use the docking station. Keep this document nearby, so you can refer to it later.

For detailed operating instructions and safety information, see www.motioncomputing.com/docs

The Motion Docking Station Model FWS-DS1is marketed and/or known as the CL-Series Docking Station.

Note: The Motion Docking Station Model FWS-DS1 is compliant to the IEC/EN 60950-1:2006+A11:2009 Safety Standard for Information Technology Equipment.

Specifications

	On	Off (Storage)
Temperature	5–45° C	-20–60° C
	0–45° C (with
	SSD option)
Humidity	8–90% RH	5–95% RH
Air pressure	697–1060 hPa	187–1060 hPa
Power supply	Input: 1.5 A, 100–240 VAC, 47–63 Hz
(ITE) Delta	Output: 19 V DC, 3.42 A
Electronics,	The power supply is compliant with
SADP-65NB	UL 60950-1, CAN/CSA C22.2
Rev. BB	No. 60950-1, and IEC/EN 60950-1

Product safety information

Motion Docking Stations are designed to optimize safety and minimize strain. However, to further reduce the risk of injury or damage to the unit, you should observe certain precautions.

Mounting and installation disclaimer

Motion Computing shall not be liable under any theory of liability (including, without limitation, contract, tort or statutory law) for any loss, damage, personal injury, or other damage of any nature (including, without limitation, direct, special, incidental or consequential damages) arising directly or indirectly as a result of improper or inappropriate placement, installation, or use of its products or any other application. To safely install and use Motion products, full consideration of occupants, systems (e.g., the location of fuel lines, navigation systems, brakes lines, electrical, drive train or other systems), air-bags and other back-up, warning or safety equipment is required. Without limiting the foregoing, Motion specifically disclaims any responsibility for the placement, use, or installation of its products not consistent with (i) the original manufacturer’s or governmental or regulatory specifications and recommendations for the environment where the products will be placed, used, or installed, (ii) Motion written product instruction sheets, or (iii) workmanship standards.

Setup precautions

•Read the installation instructions before connecting the docking station to the power supply.

•Place the docking station on a level surface so that it does not fall over and damage the unit, the docking station, or other components.

•Do not use the docking station adapter for other equipment. This can generate heat or fire. In addition, do not use other AC adapters with the docking station.

Basic personal safety precautions

•Do not attempt to service the docking station nor its components yourself. Perform only those service procedures for which Motion provides special instructions, for example, installing a peripheral device.

•Do not connect or disconnect any cables or perform maintenance or reconfiguration of this product during an electrical storm.

Docking station disposal

•Do not dispose of the CL-Series Docking Station with general waste.

•If you cannot locate a disposal site, contact your reseller or Motion Computing for assistance in locating a disposal site near your locale.

Cabling and power cord precautions

•Power cord sets for use in other countries must meet the requirements of that country. Use the appropriate AC adapter and power cord for your locale. For information about power cord set requirements, contact the Motion Reseller from whom you purchased the product, or contact Motion Computing if you purchased the product from Motion Computing.

•If no power cord was provided for your docking station or an accessory, purchase a power cord that is approved for use in your country and that matches the required voltage and amperage rating.

•If you use an extension cord with your AC adapter, ensure that the total ampere rating of the products plugged into the extension cord does not exceed the ampere rating of the extension cord.

•When using your power cord, make sure to position it around objects so it will not be cut or punctured.

Component replacement precautions

•Components currently available from Motion Computing as replaceable parts include the AC power adapter (rated for general use). Components may change from time to time. Contact Motion Computing for more information or if you have any questions about replacing a specific component.

Environmental statements

•This product is in compliance with Directive 2002/95/EC of the European Parliament and of the Council set into force in January 2003. This Directive set into force procedures regarding the restriction of the use of certain substances in electric and electrical equipment (ROHS).

•This product is in compliance with Directive 2002/96/EC of the European Parliament and of the Council set into force in January 2003. This Directive set into force procedures regarding the Waste of Electrical and

1 English