Site Configuration
5-41
67 European standard
Hanging up an unused line by INITIATOR after <1-60> Sec [20]:
A period of quiet time at the end of which the initiator of the conversation hangs up the phone.
Hanging up an unused line by RESPONDER after <1-120> Sec [120]:
A period of quiet time at the end of which the responder hangs up the phone.
Number of dial retries <1-10> [3]:
The number of times the number will be redialed (in addition to the first time) in order to
establish communications with a unit.
Interval between retries <1-30> Sec [7]:
Interval of time between a failure to establish communications (BUSY, NO ANSWER) and
the next dialing. However, if a line is busy and another line is available, the attempt is renewed
through the other line without delay.
Number of rings for answer <1-255> [2]:
Number of rings to wait for the called party to answer.
Wait for data carrier <1-255> *100mSec [250]:
A waiting period between the end of dialing and the reception of the connection signal from
the answering modem. After this period, the attempt is considered to be a failure.
Lost carrier to hang-up delay <1-255> *100mSec [20]:
The period of time during which disconnection is delayed after the carrier is lost.
Wait for dial tone <1-255> *100mSec [50]:
The amount of time the calling device should wait until it gets the dial tone.
Wait time after hang-up <1-255> *100mSec [35]:
The minimum time that should elapse between two attempts to obtain a line.
Number of dial tone retry <1-20> [3]:
Number of retries to obtain a line.
Blind dialing [NO]:
The valid values are:
NO Wait for the dial tone
YES Dial after a pre-defined period of time (blind dialing).
HDLC 'RTS' control [AUTO]:
The valid values are:
AUTO RTS runs automatically before the transmission and terminates after the
transmission