Motorola B801 manual Registration, Register a handset, Base reset

NOTE

If, in the future, your telephone service provider requires you to dial 10 digits to make a local call (area code + phone number), re-program the home area code by following the steps above. With the home area code displayed, press and hold /to remove the contents. The home area code will now be restored to its default setting of _ _ _.

6.3.4Base reset

Press Pwhen in idle mode to enter the feature menu.

1.Press ,to scroll to >SETUP BS.

2.Press Pand ,to select >RESET.

3.Press Pand RESET? will be prompted.

4.Press Pto confirm and reset all the personalized settings of base to default.

7. Registration

Your new telephone system can accommodate up to 5 handsets. You can add new handsets to your telephone system, but each device must be registered with the telephone base before use.

7.1Register a handset

Handsets purchased separately need to be registered to the telephone base before use. When first purchased, all expansion handsets will show NOT REGISTERED on the screen. The new handset(s) may need to be charged for five minutes before registering to the telephone base.

1.Place the unregistered handset into the telephone base. If PRESS FIND FOR 4 SEC ON BASE does not appear on the handset screen after a few seconds, remove the handset and place it in the telephone base again.

2.On the telephone base, press and hold afor about four seconds (until the red IN USE light on the telephone base turns on and flashes slowly) and then release the button. The handset will show PLEASE WAIT... and it will

Registration 41