Motorola BRAVO PLUS Battery Information, Cleaning Your Bravo Plus Pager, Repair and Maintenance

Message Slot Number: At the end of each message, pre-	BATTERY INFORMATION
ceding the time stamp, the message slot number is dis-
played to indicate the order in which the message was re-	Your BRAVO PLUS pager is designed to operate with a
ceived. (Example: 09 10:30a: the 09 indicates the ninth	single AA-size alkaline battery.
message received.)	Installing/Replacing the Battery
Erase All: All read, unlocked messages can be deleted
from memory using the “Erase All” function.
Backlighted Display: Press the On/Off Switch for back-		DIAGRAM
lighting in low-light conditions.
Freeze Screen : When reading a message, you can
“freeze” it on the screen by pressing and holdingR.
SILENT: When in the SILENT mode, the pager does not		(+)
give an audible alert.
CLEANING YOUR BRAVO PLUS PAGER		LOCK	(–)
		BATTERY DOOR
To clean the exterior of the BRAVO PLUS pager, use a
soft, non-abrasive cloth moistened in a mild soap and wa-
ter solution. Use a second cloth moistened in clean water
	• Locate the ribbed lock on the bottom of the pager. Slide
to wipe the surface clean. Do not immerse in water. Do not
	the lock toward the back cover to expose the red marking.
use alcohol or other cleaning solutions.
	• While pressing on the recess of the battery door, slide
REPAIR AND MAINTENANCE
	the door in the direction of the arrow until it pops up from
	the housing.
The BRAVO PLUS numeric display pager, properly han-
	• Align the battery so the polarity markings (+ and -) match
dled, is capable of many years of trouble-free service.
	the markings on the back cover. Insert the battery.
However, if service is required, Motorola's National Service
	• Align the semicircle on the battery door with the semicircle
Organization, staffed with specially trained technicians, of-
fers strategically located repair and maintenance facilities.	on the bottom of the pager near the word “LOCK”. Press
Consult your Motorola sales representative for service lo-	down on the end of the door nearest the battery and slide
cations in your area.	the battery door until it is completely closed.
	• After the cover is closed, slide the lock toward the front
	of the pager to conceal the red marking.
	Low-Battery Indicator
	When the battery nears the end of its life, the standby
	screen is replaced with lo cell. The battery must be re-
	placed within a few days to avoid interruption of pager op-
	eration.
9	10
PATENT INFORMATION
The BRAVO PLUS and BRAVO PLUS Auto Synthesized
pagers are manufactured under one or more Motorola U.S.
patents. A partial listing of these patents can be viewed on
the back cover upon removal of the belt clip. Other U.S
patents for these products are pending.
REMOVING THE BELT CLIP
	t, Motorola, and BRAVO PLUS are trademarks or registered
Position the pager so that the display faces you. Rotate the
		trademarks of Motorola Inc.
pager until the belt clip is pointing up (R and F buttons
pointing toward the ground). Hold the belt clip in one hand.
Use your other hand to push down on the small black	 1991-1995 by Motorola, Inc., Paging Products Group
spring-loaded tab (located between the two metallic tabs	1500 Gateway Boulevard, Boynton Beach, FL 33426-8292
on the pager housing) with either your finger or a coin.		All rights reserved.
With this tab held down, slide the belt clip toward you until
it is free of the housing.		Printed in U.S.A. 3/95

@6881012B23@

6881012B23-D

11