PUTTING THE BATTERIES INTO THE REMOTE CONTROL UNIT
Press down the compartment cover, and slide the cover off to open the compartment. Place the two (UM4), (AAA), (R03) batteries in the remote control according to the polarity markings ("+" and " - ") inside the compartment and on the batteries. Place the cover over the compartment, press down lightly, and push it upward until it snaps on.
NOTE : Remove the batteries from the remote control if not in use for long period of the time. Do not mix normal batteries with rechargeable batteries, when the batteries become weak, remote control will not function and replace with new batteries.
INSTALLING THE SPEAKER WIRE
TO THE SPEAKER TERMINALS
1. Speakers Connection
Extend the SPEAKER WIRES and con nect them to the SPEAKER TERMINALS.
2. Power Cord Connection
Before using , connect the AC Power Cord to the AC outlet .then turn on the main switch of the unit.
OPERATING THE UNIT
When you first plug the unit into the AC outlet , the unit will be in standby mode , You can press the POWER/STANDBY button on the unit ( or on the remote control ) to switch the unit ON and OFF. Pull the AC plug out of the wall socket if you want to switch off completely.
POWER/STANDBY
1.Press POWER/STANDBY button on the unit (or remote) to switch the unit on.
2.Select the sound source (CD , Tape , Aux, or Tuner) by pressing FUNCTION button. The corresponding display will light up.
3.Adjust the volume with the VOLUME (UP or DOWN) button.
4.Set the preset equalizer ( pass, classic , rock , pop, or jazz) with the EQ button on the Remote.
5.Press POWER/STANDBY button again to turn off the unit.
