TO SET SLEEP FUNCTION (for remote handset)
1.If you want to fall asleep to music, press SLEEP button on the remote.
2. You may adjust the Radio or CD player's sleep function to play from 90, 80, 70 up to 10 minutes of music before shutting itself off automatically.
RADIO OPERATION
Press the FUNCTION button to the TUNER mode on the unit (or remote),you can selected the Radio operation.
1.Press the BAND button to select wave band range appearing on the display.
2.Select the desired wave band range with the TUNING / SKIP / SEARCH (UP or DOWN) button.
BAND SELECT
To tune for weak stations, use manual tuning by pressing TUNING / SKIP / SEARCH (UP or DOWN) button continuously until you read the correct frequency or the reception at its best.
MONO/ STEREO SELECT
You can use only FM mode.
1.When you want to select FM stereo station, press the MONO/STEREO button .
When you receive a FM stereo station the "
" indicator will appear on the display.
2.When you press the MONO/STEREO button again , the FM STEREO indicator will turn off & switch to MONO FM stratus.
Automatic Tuning
1.Press the TUNING / SKIP / SEARCH (UP or DOWN) button for a second or more, then release the button. The tuner will automatically for the first station of sufficient signal strength.
2.Repeat above procedure if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up to10 AM and 10 FM stations in its memory. To store your selected broadcasting stations:
1.Press the BAND button on the unit(or remote) to toggle between AM and FM to make your selection.
2.Tune to the required station.
3.Press the MEMORY /
4.Press the PRESET/FOLDER(UP or DOWN) button for your desired station number.
5.Press the MEMORY /
6.To program more stations into memory, repeat the above steps 2 to 5.
7.To change the stored preset stations, repeat the above steps 2 to 5.
Notes:
1.Storing a new station into a preset location will erase the previously stored station in that location.
2.Power off / failure or power cord disconnection will clear the memory of all preset stations. Perform the stations presetting procedures again to store the stations.
