Connecting the IR Blaster

To connect the IR Blaster:

1Fit the transmitter into the mounting bracket (refer to Figure 2-3).

2Plug the mini-pin connector into the ir jack on the rear panel:

Figure 2-4

IR Blaster installed

3Remove the adhesive tape cover from the mounting bracket.

4Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be careful to route the wire so that it does not prevent loading tapes.

Checking the IR Blaster

The IR Blaster is now located near the receiver and the VCR can be controlled through the cable terminal. As a final check, operate the VCR using the remote control from various positions in the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.

34