Chapter 8 RS-232 Interface
Introduction
This chapter describes how to set up the digital imager scanner with an RS-232 host. Use the RS-232 interface to
connect the digital imager scanner to point-of-sale devices, host computers, or other devices with an available
RS-232 port (e.g., com port).
If your host does not appear in Table 8-2, refer to the documentation for the host device to set communication
parameters to match the host.
Throughout the programming bar code menus, asterisks (*) indicate default values.
NOTE The digital imager scanner uses TTL RS-232 signal levels, which interface with most system architectures.
For system architectures requiring RS-232C signal levels, Motorola offers different cables providing
TTL-to-RS-232C conversion. Contact Motorola Enterprise Mobility Support for more information.
*Baud Rate 57,600 Feature/Option
* Indicates Default
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.