Download | After the front panel amber “light pipes” have been blinking |
Operation | for about 1 minute, pull the plug and power cycle the STB. |
| The “Download In Progress” screen will automatically |
| appear on the channel ¾ or the Composite Input on the TV. |
| The download screen is not visible on the Component Input |
| on the TV. The row that starts with DL: shows how far |
| along the download is. The last number in that row will |
| count down to zero (0) as the download files are received. |
| The download should take less than 20 minutes to complete. |
| There is a timer in the top right corner that should continue |
| to move. If the timer stops, wait a few minutes. If the timer |
| does not start to move again, call for assistance. |
|
|
| After the download is complete, the TV screen will go |
| black, and the STB front panel amber “light pipes” will |
| begin to cycle/flash. |
| Wait about 2 minutes for this operation to complete. |
| Note: Download files are delivered over the satellite in a |
| carousel manner. If the STB misses a file due to bad |
| weather, poor dish alignment, or some other anomaly, the |
| unit will have to wait until another pass of that file is |
| delivered over the satellite. |
|
|
VoOm! | After 2 minutes, the unit should automatically reboot, and |
| you should be watching TV! If after 3 minutes, the “light |
| pipes” are still flashing, pull the plug to reboot the STB. |
|
|
Congratulations, download and initial activation is complete! The STB video outputs may now be connected to any of the standard definition or high definition TV or home theatre video components in the homeowners system. The video mode button may have to be pressed to match the output mode of the viewing device. Once this is set, it should not have to be set again. The lightbars (from top to bottom) indicate the following video modes: 1080i, 720p,480p, 480i).
4