Software Upgrade, Flexing, Testing on HP8922

		good one. Reassemble unit. Place call to portable
		phone and verify ability to answer by opening flip. If
		fault still present, replace original reed switch and
		proceed to c.

	c) Logic/RF Board Assembly	Replace Logic/RF Board Assembly (refer to
	Defective.	symptom 1c). Verify that the
		Fault has been cleared and re-assembles the unit with
		the new PCB.
9. Internal Charger not working	a) Faulty charger circuit on main	Test a selection of batteries in the rear pocket of the
	Board.	desktop charger.
		Check LED display for the charging indications. If
		these are charging ok,
		then the internal charger is at fault.
		Replace Logic/RF Board Assembly (refer to
		symptom 1c). Verify that the
		Fault has been cleared and re-assembles the unit with
		the new PCB.
10. No / Weak audio when using	a) Headset not fully pushed	Fully ensure the ‘click’is felt on the jack socket.
headset	home
	b) Faulty Jack Socket /	Replace Logic/RF Board Assembly (refer to
	Defective PCB	symptom 1c). Verify that the
		fault has been cleared and re-assemble the unit with
		the new PCB.

6.5Software Upgrade

For information on setting up and equipment required for the flashing of software, contact should be made with the local technical support engineer.

For information on setting up and equipment for flexing, contact should be made with the local technical support engineer.

Power Supply

HP8922

GSM Test

27 of 45

European Customer Services