Broadband

Modem

Ethernet port

WAN

Motorola voice terminal

 

 

 

 

 

LINE 1

 

PC

 

 

 

 

 

Ethernet port

Phone

Computer

Installation With A Single Computer

To connect your Motorola voice terminal as shown in “Sample Configuration Without A Home Network” on page 2:

1Be sure the Motorola voice terminal is unplugged. Be sure power is off to your broadband modem (cable or DSL) and computer.

2Connect one end of an Ethernet cable (RJ-45) to the Ethernet connector on your broadband modem. Connect the other end of this Ethernet cable to the WAN connector on the Motorola voice terminal.

3Connect one end of another Ethernet cable to the PC connector on the Motorola voice terminal. Connect the other end of this Ethernet cable to the Ethernet connector on the computer.

4Connect a telephone to the LINE 1 connector using a phone wire (RJ-11). For a VT1005v only, you can connect a second telephone to the LINE 2 connector.

5Power on the broadband modem, following the instructions provided with your modem. Wait about two minutes for it to start up.

6Plug the AC power adapter to the POWER connector on your Motorola voice terminal and the electrical outlet. This turns your Motorola voice terminal on. You do not need to unplug it when not in use.

Wait about two minutes for the Motorola voice terminal to start up. The POWER light blinks as described in “Front Panel” on page 7.

12

Page 18
Image 18
Motorola MOT-VT1005 warranty Installation With a Single Computer