Motorola RMU2040 manual Reading CTCSS/DPL Values, Reading Auto-Scan Values, Saving Settings

PROGRAMMING FEATURES

Reading CTCSS/DPL Values

If you continue short pressing the PTT button the radio will move forward to programming CTCSS/PL Codes.

After hearing the current value for CTCSS/PL Code you can scroll to a new code value using the SB1 or SB2 button.

RM Series have up to 122 codes available (refer to “Frequencies and Codes Charts” Section).

Reading Auto-Scan Values

After hearing the CTCSS/DPL codes, short press the PTT button and the radio will move forward to programming Auto-Scan. Auto-Scan only has two values:

-Enabled

-Disabled

Note: While in Auto-Scan Mode, if you short press

PTT button, the radio will move forward to programming the "Active Channels" feature, so you can modify the amount of channels available for your unit using the SB1 or SB2 button.

Saving Settings

If you are satisfied with the setting, you can either:

•short press PTT to continue programming,

•long press PTT to save and return to 'Idle' Programming Mode, or

•long press the PTT button twice to exit 'Idle' Programming Mode and return to the normal radio operation.

Note:

•If you do not wish to save the value you just programmed, turn the radio OFF.

•If you ‘roll-over’ to the beginning of ‘Idle’ Programming Mode you will hear "Channel #" and the LED Indicator will start blinking green again. All values that were changed will be automatically saved.

English 38