Motorola XPR 4580 - page 32

Advanced Features

English

22

Responding to a Transmission During a Scan

During scanning, your radio stops on a channel/group where

activity is detected. The radio stays on that channel for a

programmed time period known as “hang time”.

Procedure:

1Press the PTT button during hang time. The green LED

lights up.

2Wait for the Talk Permit Tone to finish (if enabled) and

speak clearly into the microphone.

3Release the PTT button to listen.

4If you do not respond within the hang time, the radio returns

to scanning other channels/groups.

Deleting a Nuisance Channel

If a channel continually generates unwanted calls or noise

(termed a “nuisance” channel), you can temporarily remove the

unwanted channel from the scan list.

This capability does not apply to the channel designated as the

Selected Channel.

Procedure:

1When your radio “locks on to” an unwanted or nuisance

channel, press the programmed Nuisance Delete button

until you hear a tone.

2Release the Nuisance Delete button. The nuisance

channel is deleted.

Deleting a “nuisance” channel is only possible through the

programmed Nuisance Delete button. This feature is not

accessible through the menu.

Restoring a Nuisance Channel

Procedure:

To restore the deleted nuisance channel, do ONE of the

following:

•Turn the radio off and then powering it on again, OR

•Stop and restart a scan via the programmed Scan button or

menu, OR

•Change the channel via the Channel Rocker.







NAG_LACR.book Page 22 Thursday, November 12, 2009 10:17 AM

Contents

Main Page i DECLARATION OF CONFORMITY ii iii iv v Page Important Safety Information ! vii Important Safety Information Product Safety and RF Exposure Compliance ATTENTION! viii Computer Software Copyrights How to Use This User Guide What Your Dealer/System Administrator Can Tell You Powering Up the Radio Adjusting the Volume Radio Controls You Will Be Using Programmable Buttons Assignable Radio Functions Accessing the Programmed Functions Push-To-Talk (PTT) Button Switching Between Conventional and Trunking Mode Display Icons Call Icons Main Menu Icons In-Menu Icons LED Indicators Audio Tones CH - Indicator Tones P1 OK P2 Selecting a Zone 2Por Q to Zone and press N to select. 3 4Por Q to the required zone and press N to select. 5 Selecting a Radio Channel Receiving and Responding to a Radio Call CH - Receiving and Responding to a Group Call 1 2 Page Making a Radio Call Page Making an Enhanced Private Call 1 2 3 4 1 5 6 Page Using the Dynamic Regrouping Feature 1 2 Talkaround Permanent Monitor Scan Lists Viewing an Entry in the Scan List 2Por Q to Scan and press N to select. 3Por Q to View/Edit List and press N to select. 4 Editing the Scan List Adding a New Entry to the Scan List Page Scan Page Contacts Settings Call Indicator Settings Call Log Features Call Alert Operation Page Emergency Operation Page Page Page Page Trunking System Controls Using the Failsoft System 1 2 Going Out of Range Page Utilities Page Page Page Page Page Using the Keypad Additional Advanced Features Dual-Tone Multi Frequency (DTMF) Antennas Audio Cables Mounting Kits Speakers Miscellaneous Accessories MOTOROLA COMMUNICATION PRODUCTS I. WHAT THIS WARRANTY COVERS AND FOR HOW LONG: II. GENERAL PROVISIONS: III. STATE LAW RIGHTS: IV. HOW TO GET WARRANTY SERVICE: V. WHAT THIS WARRANTY DOES NOT COVER: VI. PATENT AND SOFTWARE PROVISIONS: VII. GOVERNING LAW: