Mr. Coffee ECMP2 manual Before Using Your Mr. Coffee Espresso Maker, How To Brew Espresso, cause

Before Using Your Mr. Coffee Espresso Maker

Please refer to page 5 for diagram of parts.

1. power switch off and unplug the machine from the electrical

2.Wash the water reservoir, filter basket and filter holder in a mixture of

mild detergent and water. Rinse each thoroughly and replace into machine.

3.To rinse the Inside of the machine, follow steps for “How to Brew Espresso” on pages 6-7, using waler only.

How To Brew Espresso

Please refer to page 5 for diagram of parts. First unwind The electrical cord from the bottom 0f your machine.

Filling the Water Tank...

1.Make sure the steam selector control knob is in the OFF position. Turn the machine OFF and make sure the brew switch is in the “0” OFF posi- tion.

2.Remove the water reservoir by opening the lid and lifting up the reservoir handle. Fill the water reservoir with fresh, cold water to the top of the reservoir (29 ounce capacity).

Never fill below the minimum line level indicated on the, outside of the reservoir. Insert the water reservoir into the machine. If the water reservoir is not Inserted properly Into the machine, the valve on the bottom of the reservoir will not be activated. The water reservoir lid will close only If the reservoir is prop erly Inserted and the valve is opened. Do not force the water container In any other way into the machine.

3.The pump must be primed whenever the machine is being used for the first time or if not used In a long time. This procedure prepares the pump and fills the water boiler with water.

4.plug the power cord Into an eteclric outlet.

5.PIace a frothing pitcher or large cup (with 16 ounce capacity) half full of water under the frothing tube. Submerge the tip of the frothing tube in the water.

6.Turn-the machine ON. Leave the brew switch in the OFF position. Turn the steam selector control nob to the ON position. After a few seconds a HOT stream of water will emerge from the frothing tube. Allow one cup of water to flow through the frothing tube.

7.Shut the steam selector control knob OFF. Your espresso/cappuccino maker is now primed.

Preparing the Coffee...

1.Remove the filter holder by grabbing the filter handle and sliding l/4 to the left. Th e filter

holder will now release.

2.Place either one of the filter baskets (1 =for one l-1/2 ounce cu of espresso: 2=for two 1-1/2ounce cups o es resso) lnto the filter

holder. See	ure 1.	wtlh fresh fine		round espresso coffee (one
spoon,	ilter
flat spoon per cup). Do not			the	basket. This might
cause	Ing or over flow.		Tamp (tap lightly, but do not pack)the
grounds	-the flat disc at the end of the handle of the

spoon. Clean any excess coffee from the rim of the filter holder. hls will assure proper fit under the brew head.

3.Make sure filter retainer clip Is away from the filter basket.