Mr. Coffee ECMP2 holder at any time during the brewing, process. Do not let the pump run with an

FIGURE 2

4. Place the filter holder underneath the brew head so that the handle is positioned to the left off center. Lift the filter holder up and Insert into the brew head and turn to the right. Make sure the filter holder is positioned to the right of the “min” (minimum) mark. The filter holder must be secure. See figure 2.

Brewing Espresso...

1.Remove the water reservoir and fill to the top of the water reservoir capacity (29 ounce capacity) and place into the tank securely. Close Iid.

2. Make sure the drip grate on the drip tray is in		- -
	place.
3.	Align either one or two demitasse cups under	I
	the filter holder on the drip tray.
		,
4. Make sure the steam control knob is in
	the OFF position, the on/off switch is OFF
	and the brew switch is on the “0” OFF position.
	See figure 3.
5.	Plug the power cord Into an electrical outlet.	FIGURE 3
	Turn the on/off switch ON. The brew light will
	illuminate to let you know the machine is on.
	When the brew light shuts off, turn the brew
	switch to the CUP position. The machine is now
	ready to brew espresso. Espresso will begin to
	flow in a few seconds. Do not remove the filter
	holder at any time during the brewing
	process. Do not let the pump run with an

empty water container. This can damage the pump permanently.

When the demitasse cup(s) are about half full

(about l-1/2 ounces) press the brew switch to the OFF “0’ position. Turn the on/off switch OFF. If you are making cappuccino leave the on/off switch ON to froth milk. (See page 8 formaking cappuccino).

7.Unplug the power cord and allow the machine to cool.

8.To make additional cup(s) and after the machine has cooled down, remove the filter holder from the brew head CAUTION: The metal parts of the filter holder might still be very hot. Also there may be

hot water floating on the top of the filter basket. Hold the filter holder

,steady; Using the filter retainer clip to secure the filter basket in the

filter holder, turn the filter holder upside down to empty Rinse the filter basket and holder with cold water.

8.Remove the water reservoir using the attached handle. Discard any excess water.

9.Carefully remove drip tray and grate and clean any excess water or espresso that has accumulated.

10.See for cleaning on page 10.

7