Mr. Heater MH15 Assembly Procedure, Lighting Instructions, Shutdown And Storage Instructions

Models: MH15

1 16
Download 16 pages 54.73 Kb
Page 6
Image 6
ASSEMBLY PROCEDURE

ASSEMBLY PROCEDURE

A.Make sure the regulator knob on the heater is ”off” by turning knob clockwise to the “OFF” position.

B.Screw disposable cylinder hand tight into the Inlet tapping of the regulator. Make sure gas cylinder is in upward position.

C.Firmly place disposable cylinder into plastic stand. (See Fig. 2.)

D.Tighten knurled lock nut.

LIGHTING INSTRUCTIONS

A.Before attempting to light the heater, check all fittings and connections with a soap solution. NEVER USE A MATCH TO CHECK FOR LEAKS. Should a gas leak occur, do not attempt to repair or use heater. Return the heater to your dealer or the address given on the last page.

B.Turn the heater’s “Hi-Med-Lo-Off” regulator knob to “Med” (counterclockwise).

C.To light heater, place a lit match across the mesh screen where you see “light here” on reflector. (See Fig. 5 and Fig. 6). THEN push in valve button on Safety Shutoff Valve. After the heater is lit, continue to hold valve but- ton in for 30 seconds, then release the button slowly.

Reset Button LIGHTING INSTRUCTIONS

Figure 5

Stock No. F242200

NOTE: WHEN LIGHTING BURNER WITH A MATCH OR TAPER, LIGHT AT SCREEN. (NOT AT ORIFICE)

CAUTION: DO NOT PUSH IN VALVE BUTTON BEFORE INSERTING LIT MATCH. NEVER use a spark lighter to light heater.

D.If burner does not light within 30 seconds, turn the heater’s regulator knob to “off” (clockwise) and allow at least five minutes for gas to dissipate before attempting to relight.

E.NOTE: Should the orifice become clogged as indicated by low volume of gas when operating on “Hi” with a full cylinder, or should the heater fail to operate properly for any reason, return the heater to the dealer or the address given on the last page for repair or replacement.

DO NOT ATTEMPT TO REPAIR OR TAMPER WITH THE HEATER.

F.Adjust heat output by turning knob to desired position.

SHUTDOWN AND STORAGE

INSTRUCTIONS

A.When shutting off the heater, turn the regulator knob on the heater to “OFF” (clockwise). (See Fig. 5).

B.CAUTION: After turning unit off, heater will remain extremely hot. Allow at least 15 minutes for cooling before handling and storing.

C.HEATER STORAGE: Always remove the propane cylinder from the heater when not in use. Always store propane cylinders in a cool, well ventilated place away from any flame or heat and in a location not used for habitation. DO NOT STORE PROPANE TANK WITHIN 60 FEET OF OPEN FLAME OR HEAT.

D.See Figure 6 for spare parts list.

E6

Page 6
Image 6
Mr. Heater MH15 operating instructions Assembly Procedure, Lighting Instructions, Shutdown And Storage Instructions