1.Wrap the throttle wire once around the handlebar. See Figure 9.
2.Depress the throttle trigger and locate hole for the throttle wire. See Figure 10.
3.With the throttle trigger depressed, place the bar- rel end of the throttle wire inside the hole of the trigger. See Figure 11.
4.Release the throttle trigger and guide the cable up into the slot of the trigger housing.
5.Push the throttle cable housing into the trigger housing until it snaps into place. See Figure 12.
6.Route the throttle cable through the clip on the right handlebar mounting bracket. See Figure 13.
NOTE: Ensure the throttle cable is fitting into the guide at the carburetor plate on the engine. If it does not, the throttle will not work properly. See Figure 9.
Carburetor
Plate Guide
Throttle Cable
Figure 9
Throttle Wire Hole
Figure 10
Throttle
Wire Slot
Figure 11
Figure 12
Throttle
Cable
Engine
Mounting
Bracket
Figure 13
7