6
Adjustments
&
Maintenance
WARNING
Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.
NEVER attempt to make any adjust- ments while
the engine is run- ning, except where specified in
the operator’s manual.
Before servicing, repairing, or inspect- ing, disengage the control bail and stop engine. Wait until all moving parts have come to a complete stop.
Side View
Figure 7
Figure 8
WARNING: Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.
WARNING: NEVER attempt to make any adjustments while the engine is running, except where specified in the operator’s manual.
Shave Plate
1.To check the adjustment of the shave plate, place the unit on a level surface. The wheels, shave plate and augers should all contact level surface. Note that if the shave plate is adjusted too high, snow may blow under the housing. If the shave plate wears out excessively, or the unit does not
NOTE: On new units or units with a new shave plate installed, the augers may be slightly off the ground.
2.To adjust, tip the snow thrower back so that it rests on the handle. Loosen the lock nuts and bolts which secure the shave plate to the housing. See Figure 7. Move the shave plate to desired position and retighten the nuts and bolts securely.
Replacing Shave Plate
The shave plate is attached to the bottom of the auger housing and is subject to wear. It should be checked periodically. There are two wearing edges and the shave plate can be reversed. Refer to Figure 7.
1.Remove the carriage bolts and hex lock nuts which attach it to the snow thrower housing.
2.Install new shave plate, making sure the heads of the carriage bolts are on the inside of the housing.
3.Adjust the shave plate according to instructions above. Tighten the nuts securely before operating the snow thrower.
NOTE: For information regarding the price and availability of Shave Plate Kit refer to customer support on page 2.
Control Cable
As a result of both the control cable and the drive belt stretching due to wear, periodic adjustments may be necessary.
If the auger seems to hesitate when rotating while the engine maintains a constant speed, an adjustment is necessary. Proceed as follows:
The upper hole in the control handle provides for an adjustment in cable tension. To adjust, disconnect the end of control cable from the bottom hole in the control handle and reinsert it in the upper hole. Insert the cable from the outside as shown in Figure 8. Test the snow thrower to see if there is a noticeable difference.
Carburetor
WARNING: If any adjustments need to be made to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts. Be careful of muffler, engine and other surrounding heated surfaces.
1.Refer to the separate engine manual, packed with your unit, for carburetor adjustment information.
10
