14.5.Use needle nose pliers to remove the hairpin clip from the clevis pin securing the 4-way chute control assembly to the chute support tube. Remove the clevis pin. See Figure 36.

4-Way Chute Control

Hairpin Clip

Figure 36

14.6.Remove the control assembly and set it on the engine.

14.7.Using a ½” socket, remove the AB screw secur- ing the lower portion of the chute support tube to the frame. See Figure 37.

AB screws

Figure 37

14.8.Using a ½” socket, remove the TT screw, handle tab and washer securing the support tube to the frame. Remove the support tube from the unit.

See Figure 38.

Frame Screws

Support Tube

Figure 38

14.9.Using a 3/8” socket, remove the AB screw securing the auger cable guide bracket to the frame. See Figure 39.

Auger Cable Bracket

Figure 39

14.10.Using a ½” socket, remove the 4 bolts (2 on each side) securing the auger housing assembly to the wheel drive frame.

12