18.REDUCER TRANSMISSION
18.1.The reducer can be serviced. It can also be pur- chased as an assembly.
NOTE: On the top of the gearbox is inspection and access hole for adding grease when and if required. Remove the rubber grommet from the lubrication port. See Figure 51.
Rubber Grommet 
Reducer Transmission
Figure 51
19.REDUCTION TRANSMISSION DISASSEMBLY
19.1.Using a 3/8” socket, remove the 5 TT screws securing the reducer halves together. See Fig- ure 52.
5 TT Screws
19.2.Separate the housing halves using a putty knife. See Figure 53.
19.3.Inspect all internal parts for wear or damage.
Ultra Gray
Figure 53
NOTE: before assembly, clean off all of the ultra- gray sealant on both sides of the gearbox hous- ing. Use ultra gray to reseal the housing before assembly.
20.AUGER IDLER ARM
20.1.Split the unit. Refer to the SPLIT THE UNIT Sec- tion.
20.2.Remove the auger pulley. Refer to AUGER PUL- LEY REMOVAL Section.
Figure 52
16