NOTE: During reassembly note that there are two mounting holes in the friciton wheel support bracket. The friciton wheel disc must be installed in the left hand hole as you face the friction wheel support bracket. See Figure 44.
Assemble in left mounting hole
16.4.Inspect the pulley and adapter for any wear or damage.
NOTE: During reassembly use Loctite 242 on the screw.
NOTE: Torque to
17.AUGER AND IMPELLER REMOVAL
17.1.Remove the Auger Pulley as covered in the AUGER PULLEY REMOVAL Section..
17.2.Using a ½” socket, remove the two flange lock nuts securing the bearing housing to the auger housing. Remove the bearing housing and bear- ing and inspect for wear or damage. See Figure 46.
Figure 44
16.AUGER PULLEY REMOVAL
16.1.Split the unit in two. Refer to the SPLITTING THE UNIT Section.
16.2.Wedge a 2x4 between the spiral assembly and the auger hosing to hold it in place. See Figure 45.
2x4 
Auger Pulley Flat Washer Screw
Figure 45
16.3.Using a 1/’2” socket, remove the screw and flat washer securing the auger pulley to the impeller assembly.
Flange Lock Nuts
Figure 46
NOTE: The two carriage bolts used to secure the bearing housing are held in place by
17.3. Lay the auger housing on its face.
14