SECTION 5: MAKING ADJUSTMENTS
WARNING: Disconnect the spark plug wire and ground against the engine before performing any adjustments, repairs, or maintenance.
Clutch Control Adjustments
To adjust the clutch controls, refer to the Final Adjustment section of assembly instructions.
Tine Width Adjustment
The tilling width of the unit is 22 inches. See Figure 15. Tilling width can be increased to 24 inches by removing the clevis pins and hairpin clips, sliding the outer tines out one inch, and securing in this position with the clevis pins and hairpin clips. See Figure 15. For cultivation, reduce the tine width to 13 inches by removing the outer tines completely.
Wheel Adjustments
To adjust the wheel yoke and wheel position, refer to OPERATING YOUR TILLER in Section 4.
Depth Stake Adjustment
To adjust the depth stake, refer to OPERATING YOUR TILLER in Section 4.
22”
24”
13”
Figure 15
Carburetor Adjustment
WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), disengage all clutches and tines. Keep clear of all moving parts. Be careful of heated surfaces and muffler.
Minor carburetor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If adjustments are needed, refer to the engine manual packed with the tiller.
NOTE: A dirty air cleaner will cause engine to run rough. Be certain air cleaner is clean and attached to the carburetor before adjusting carburetor. Do not make unnecessary adjustments. Factory settings are satisfactory for most applications and conditions.
12
