SECTION 8: TROUBLE SHOOTING GUIDE
Trouble
Engine fails to start
Engine runs erratic
Engine over- heats
Tines do not engage
Possible Cause(s)
Fuel tank empty, or stale fuel.
Throttle control lever not in correct starting position (if so equipped). Blocked fuel line.
Dirty aircleaner.
Choke not in ON position. Spark plug wire disconnected. Faulty spark plug.
Engine flooded.
Unit running on CHOKE. Spark plug wire loose. Blocked fuel line or stale fuel.
Vent in gas cap plugged. Water or dirt in fuel system. Dirty air cleaner.
Carburetor out of adjustment. Engine oil level low.
Dirty air cleaner. Air flow restricted.
Carburetor not adjusted properly. Foreign object lodged in tines. Tine clevis pin(s) missing. Pulley and idler not in correct adjustment.
Control cable not adjusted properly. Belt worn and/or stretched.
Corrective Action
Fill tank with clean, fresh gasoline. Fuel will not last over thirty days unless a fuel stabilizer is used.
Move throttle lever to start position.
Clean fuel line.
Refer to the engine manual packed with your unit. Move switch to ON position.
Connect wire to spark plug. Clean, adjust gap or replace.
Refer to the engine manual packed with your unit. Move choke lever to OFF position.
Connect and tighten spark plug wire.
Clean fuel line; fill tank with clean, fresh gasoline. Fuel will not last over thirty days unless a fuel stabilizer is used. Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to the engine manual packed with your unit. Refer to the engine manual packed with your unit. Fill crankcase with proper oil.
Refer to the engine manual packed with your unit. Refer to the engine manual packed with your unit.
Adjust carburetor as instructed in separate engine manual. Dislodge foreign object.
Replace tine clevis pin(s).
Take unit to authorized service dealer.
Adjust control cable (see assembly instructions). Replace belt.
15
