MTD 410 through 419 Lubrication, Off-Season Storage, Lube, Blade Control, Rear Discharge Door

Models: 410 through 419

1 20
Download 20 pages 50.93 Kb
Page 14
Image 14
Lubrication

Maintain engine oil level as instructed in engine manual.

Service air cleaner every 25 hours under normal conditions. Clean every few hours under extremely dusty conditions. Poor engine performance and flooding usually indicates that the air cleaner should be serviced. To service the air cleaner, refer to the engine manual.

Clean spark plug and reset the gap once a season. Spark plug replacement is recommended at the start of each mowing season. Check engine manual for correct plug type and gap specifications.

Clean engine regularly with a cloth or brush. Keep the cooling system (blower housing area) clean to permit proper air circulation. Remove all grass, dirt and combustible debris from muffler area.

Lubrication

Blade Control

Lubricate the pivot points on the blade control handle and the brake cable at least once a season with light oil. See Figure 16. The blade control must operate freely in both directions.

Rear Discharge Door

The torsion springs and pivot points should be lubricated periodically with light oil to prevent any rust or binding. Door must work freely.

Wheels

The wheels require no lubrication. However, if the wheels are removed for any reason, lubricate the surface of the axle bolt and the inner surface of the wheel with light oil. Engine oil may also be used.

Engine

Follow engine manual for lubrication instructions.

LUBE

LUBE

Blade ControlRear Discharge DoorWheels LUBE

EngineLUBE LUBE

LUBESECTION 8: OFF-SEASON STORAGEManual backgroundManual backgroundManual backgroundManual backgroundManual background

Figure 16

SECTION 8: OFF-SEASON STORAGE

If the lawn mower is not going to be used for 30 days or longer, prepare the unit for storage. Follow the steps below for proper storage of the mower.

Clean and lubricate mower thoroughly as described in the lubrication instructions.

Refer to engine manual for correct engine storage instructions.

Coat mower’s cutting blade with chassis grease to prevent rusting.

Store mower in a dry, clean area. Do not store next to corrosive materials, such as fertilizer.

NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all moving parts.

14

Page 14
Image 14
MTD 410 through 419 manual Lubrication, Off-Season Storage, Lube, Blade Control, Rear Discharge Door, Wheels, Engine