MAINTENANCE AND REPAIR INSTRUCTIONS

Indexing Teeth

 

Fig. 29

 

For Use with Single

For Use with SplitLine™

 

 

Line ONLY

 

or Single Line

 

Slotted

 

Holes

Fig. 30

NOTE: SplitLine™ can only be used with the inner reel with the slotted holes. Single line can be used on either type of inner reel. Use Figure 30 to identify the inner reel you have.

NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.

Loop

Fig. 31

Single Line Installation

Go To Step 8 for SplitLine™ Installation

6.Take approximately 16 feet (5 m) of new trimming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel (Fig. 31). Pull the line through the inner reel so that the loop is as small as possible.

7.Wind the lines in tight even layers, onto the reel (Fig. 32). Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line. Proceed to step 11.

Fig. 32

SplitLine™ Installation

8.Take approximately 8 feet (2.5 m) of new trimming line. Insert one end of the line through one of the two holes in the inner reel (Fig. 33). Pull the line through the inner reel until only about 4 inches is left out.

9.Insert the end of the line into the open hole in the inner reel and pull the line tight to make the loop as small as possible (Fig. 33).

10.Before winding, split the line back about 6 inches.

11.Wind the line in tight even layers in the direction indicated on the inner reel.

NOTE: Failure to wind the line in the direction indicated will cause the cutting attachment to operate incorrectly.

12.Insert the ends of the line into the two holding slots (Fig. 34).

Loop

Fig. 33

Holding Slots

Fig. 34

18