MTD 614E manual CONTENTS OF HARDWARE PACK Boxed Units

SECTION 2: CONTENTS OF HARDWARE PACK (Boxed Units)

Lay out the hardware according to the illustration below for identification purposes. Part numbers are shown in parentheses. (Hardware pack may contain extra items which are not used on your unit.)

A ATTACHING THE HANDLES Lock Washers 736-0119 (4)

Hex Bolts

710-04039 (2)

Hex Bolts	Saddle
	784-5599 (2)
710-1880 (2)

C ATTACHING CHUTE DIRECTIONAL CONTROL

Cupped Washer	Eyebolt (Not Shown)
736-0242	747-0697
	Hex Nuts
	712-3010 (2)

Flat Washer 736-0185 (1)

		Hairpin Clip
		714-0104
F	ATTACHING CHUTE ASSEMBLY
	Hex Bolts	Hex Lock Nuts
710-3015 (2)		712-3027 (6)

Chute Flange Keepers

731-0851A (3) Not Shown

B ATTACHING HANDLE PANEL Carriage Bolts 710-0262 (4)

Hex Patch Nuts 712-3068 (4)

Cupped Washers 736-0242 (4)

D ATTACHING CLUTCH CABLES AND SHIFT ROD (Z Fittings might be already attached to cables)

Hex Nuts 712-0121 (2)

Z Cable Fitting 746-0778 (2)

Ferrule	Hairpin Clips	Flat Washers
711-0677
	714-0104 (2)	736-0275 (2)

E ATTACHING THE CLUTCH GRIPS

Hex Screws 710-3103 (2)

Spacer 750-1032 (2)

Hex Top L-Nut 712-0429 (2)

G REPLACEMENT SHEAR BOLTS

Hex Lock Nuts

712-0429 (2)Hex Bolts

710-0890A (2)

NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard foreign object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and nuts are provided for your convenience. Store in a safe place until needed.

5