1
2 |
3 |
Auger Belt Replacement
To remove and replace your snow thrower’s auger belt, proceed as follows:
1.Remove the plastic belt cover on the front of the engine by removing the two
•Drain the gasoline from the snow thrower, or place a piece of plastic under the gas cap.
•Carefully pivot the snow thrower up and forward so that it rests on the auger housing.
2.Remove the frame cover from the underside of the snow thrower by removing four
3.Roll the auger belt off the engine pulley.
4.Unhook the support bracket spring from the frame.
• Loosen and remove the shoulder screw which acts as a belt keeper.
• Remove the belt from around the auger pulley, and slip the belt between the support bracket and the auger pulley
• Reassemble auger belt by following instructions in reverse order.
IMPORTANT: Do NOT forget to reinstall the shoulder screw and reconnect the spring to the frame after installing a replacement auger belt.
4 |
16
