Attaching the Chute Assembly and Directional Control
1.Apply a light lubricant (i.e.
2.Close the flange keepers to secure the chute assembly to the chute base. The flange keepers will click into place when properly secure.
3.Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed.
NOTE: If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment. on Page 14.
CAUTION: Prior to operating your snow thrower, refer to Auger Control Test on page 11. Read and follow all instructions carefully and perform all adjustments to verify your snow thrower is operating safely and properly.
Tire Pressure
•Before operating, check tire pressure and reduce pressure in both tires to between 15 psi and 20 psi.
NOTE: If the tire pressure is not equal in both tires, the unit may not travel in a straight path and the shave plate may wear unevenly.
1 |
2 |
3 |
7
