3
Setting Up
Your Snow
Thrower
NOTE: This Operator’s Manual covers several models. Snowthrower featrues vary by model. Not all features refer- enced in this manual are applicable to all snowthrower models.
NOTE: References to right or left side of the snow thrower are deter- mined from behind the unit in the operating position.
NOTE: Replacement auger shear pins and cotter pins are provided for your convenience. Store these safely until needed.
Figure 1
Figure 2
Figure 3
IMPORTANT: The snow thrower is shipped with oil and WITHOUT GASOLINE. After assembly, refer to separate engine manual for proper fuel and engine oil recom- mendations.
Loose Parts
•The augers are secured to the auger shaft with shear pins and bow tie cotter pins. If you hit a foreign object or ice jam, the snow thrower is designed so that the pins may shear. Replacement shear pins and cotter pins are provided for your convenience. Store these safely until needed.
Items Required For Assembly
Pair of pliers | 7/16” Wrenches or adjustables |
Fresh gasoline |
|
Before Assembly
•Disconnect the spark plug wire and ground it against the engine to prevent unintended starting.
•Reference to the right hand or left hand side of machine are observed from the operating position.
Assembling Handle
•Look at the lower rear of the snow thrower frame to be sure the spring (found at the end of each cable) is attached to its actuator bracket.
•Remove the lower handle knobs, washers and carriage bolts from each side of the lower handle. See Figure 2.
•Raise the upper handle assembly until it locks over the lower handle. See Figure 1.
•Secure the upper handle and lower handle with the handle knobs and carriage bolts previously removed.
•Tighten the handle knobs already in place on the upper holes and secure the handles firmly.
Attaching Chute Crank
•Remove the flat washer and hairpin clip from the end of the chute directional control. See Figure 3.
•Insert the end of the chute directional control into the lower bracket and secure with the flat washer and hairpin clip just removed. If necessary, the lower bracket can be adjusted. Refer to Chute Bracket Adjustment, in the Adjustment Section of this manual.
