WARNING: Do not use this attachment with an electric or battery-powered unit. Doing so could cause the motor to overheat, resulting in damage to the unit and possible personal injury.

WARNING: Before using any attachment, read and understand the manual that came with the attachment. Follow all safety information contained within.

WARNING: To avoid serious personal injury and damage to the unit, shut the unit off before removing or installing an attachment.

OPERATING THE COUPLER

The coupler enables the use of various optional attachments.

Installing the Attachment

1.Remove the hanger cap from the attachment. Keep the hanger cap for use when storing the attachment. If present, remove the gray spacer from the coupler.

2.Set the unit on a flat, level surface.

3.Turn the knob counterclockwise to loosen the coupler (Fig. 4).

4.Align the release button with the guide recess (Fig. 5).

5.Push the attachment straight into the coupler until the release button snaps firmly into the primary hole (Fig. 5).

6.Turn the knob clockwise to tighten the coupler (Fig. 4).

NOTE: Do not tighten the nut (Fig. 5).

CAUTION: Before operating the unit, make sure the release button is fully snapped into the primary hole and the knob is securely tightened.

CAUTION: The release button should be snapped into the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

Removing the Attachment

1.Set the unit on a flat, level surface.

2.Turn the knob counterclockwise to loosen the coupler (Fig. 4).

3.Press and hold the release button (Fig. 5).

4.Pull the attachment straight out of the coupler (Fig. 3).

CouplerAttachment

Fig. 3

Tighten

Loosen

Knob

Fig. 4

 

 

 

 

Primary Hole

 

 

 

Release Button

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Guide Recess

Nut

Fig. 5

7