ASSEMBLY INSTRUCTIONS

INSTALLING THE D-HANDLE

The D-handle may be pre-installed one some units. In this case, all that is required is the loosening of screws and D-handle adjustment. Tailor the handle to the operator. Go to step 4 for adjusting the D-handle if it is pre-installed.

Shaft Grip

(4) Screws

Shaft

Housing

Minimum 15.24 cm

(6 inches)

D-Handle

Bottom

 

Clamp

FIGURE 1

1.Remove the screws and bottom clamp piece that were installed on the D-handle for shipping.

2.Place the D-handle over the shaft housing and onto the bottom clamp. See Figure 1. Place it a minimum of 15.24 cm (6 inches) from the end of the shaft grip.

3.Start the screws with a large flathead or T25 screwdriver. Do not tighten them until you make the handle adjustment.

FIGURE 2

4.If the D-handle was pre-installed, loosen its screws just enough so that the handle slides and moves easily.

5.While holding the unit in the operating position, arrange the D-handle to the location that provides you the best grip. See Figure 2.

6.Tighten the clamp screws evenly, until the D-handle is secure.

8