2.Squeeze the auger control and the augers will turn. Release it and the augers will stop.
3.Squeeze the traction control and the snow thrower will move. Release it and drive motion will stop.
4.NEVER move shift lever without releasing trac- tion control.
OPERATING TIPS
NOTE: Allow the engine to warm up for a few min- utes as the engine will not develop full power until it reaches operating temperature.
WARNING: Temperature of muffler and surrounding areas may exceed 150 degrees Fahrenheit. Avoid these areas.
TO ENGAGE AUGERS
To engage the augers and start the snow throwing action, squeeze the auger control against the left handle. Release to stop the augers.
1.For most efficient snow removal, remove snow immediately after it falls.
2.Discharge snow downwind whenever possible. Slightly overlap each previous swath.
TIRE CHAINS (Optional Equipment)
If your unit is not equipped with tire chains, you may purchase them. Tire chains should be used when- ever extra traction is needed.
3.Set the skid shoes 1/4" below the scraper bar for normal usage. The skid shoes may be adjusted upward for
4.Be certain to follow the precautions listed under TO STOP ENGINE to prevent possible freeze- up.
5.Clean the snow thrower thoroughly after each use.
SECTION 7: ADJUSTMENTS
WARNING: NEVER attempt to clean chute or make any adjustments while engine is running. Refer to label in Fig- ure 2 in safety section.
AUGER CLUTCH ADJUSTMENT
To adjust the auger control, refer to FINAL ADJUST- MENT section of Assembly Instructions.
CHUTE ASSEMBLY ADJUSTMENT
The distance snow is thrown can be adjusted by adjusting the angle of the chute assembly. The sharper the angle, the shorter the distance snow is thrown. See Figure 19.
To adjust chute assembly, loosen the hand knob. Pivot the top of the chute assembly to position desired. Retighten the hand knob.
Hand Knob |
Figure 19
SHIFT ROD ADJUSTMENT
To adjust the shift rod, separate the shift rod and fer- rule from the shift lever by removing the hairpin clip and flat washer from the ferrule underneath the han- dle panel. Refer to Figure 11. Adjust as specified in the Assembly Instructions.
CARBURETOR ADJUSTMENT
WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts. Be careful of heated surfaces and muffler.
Minor carburetor adjustment may be required to compensate for differences in fuel, temperature, alti- tude and load.
Refer to the separate engine manual packed with your unit for carburetor adjustment information.
SKID SHOE ADJUSTMENT
The space between the shave plate and the ground can be adjusted. Refer to the ASSEMBLY section.
13
