MTD E600E Contents Of Hardware Pack, A Attaching The Handles, C Attaching The Chute Assembly

CONTENTS OF HARDWARE PACK

Lay out the hardware according to the illustration for identification purposes. Part numbers are shown in parentheses. (Hardware pack may contain extra items which are not used on your unit.)

A ATTACHING THE HANDLES			C ATTACHING THE CHUTE ASSEMBLY
	Hex Bolts
	5/16-18 x 1-3/4”
	(710-3180)	Hex Bolts
		5/16-18 x 3/4”
		(710-3008)		Hex Bolts
Handle Tabs				(710-3015)
				1/4-20 x 3/4”
(784-5599)
	Lock Washers
	5/16” I.D.
	(736-0119)
Carriage Bolts
5/16-18 x 1-1/2”			Chute Flange
(710-0262)
			Keepers
				Hex Lock Nuts
			(731-0851A)
				1/4-20 Thread
		Cupped Washers		(712-3027)
		5/16” I.D.	ATTACHING THE CHUTE DIRECTIONAL
		(736-0242)
			D CONTROL
Hex Nuts			Flat Washers
5/16” Thread
			3/8” I.D. x 5/8” O.D.
(712-3010)
			(736-0185)
ATTACHING THE SHIFT ROD
B AND CONTROL CABLES			Hex Nut
			5/16” Thread
			(712-3010)
	Flat Washers		Cupped Washers
Ferrule		Hair Pin Clip	5/16” I.D.
	3/8” I.D. x 5/8” O.D.			Hair Pin Clip
(711-0677)			(736-0242)
	(736-0275)	(714-0104)		(714-0104)
E AUGER SHEAR BOLTS (SPARES)
		Shear Bolts	Hex Lock Nuts
			5/16” Thread
		(710-0890A)
			(712-0429)

NOTE: The augers are secured to the spiral shaft with two shear bolts and hex lock nuts. If you hit a hard for- eign object or an ice jam, the snow thrower is designed so that the bolts may shear. Two replacement shear bolts and nuts are provided for your convenience. Store in a safe place until needed.

IMPORTANT: NEVER replace the auger shear bolts with standard hex bolts. Any damage to the auger gear- box or other components as a result of doing so will NOT be covered by your snow thrower’s warranty.

6