MAINTENANCE AND REPAIR INSTRUCTIONS

IMPORTANT!LUBRICATING CAMS

The cams are lubricated with a sufficient amount of high- temperature grease. To keep the attachment operating efficiently, apply a high-temperature grease to the cams, and in between the yokes every 6 hours of use. (Fig. 7)

Yokes

Cams

Fig. 7

WARNING: Failure to apply high-temperature grease every 6 hours of operation can result in failure of cams and blade, and will void your warranty.

BLADE REPLACEMENT

NOTE: We recommend that you take the hedge trimmer attachment to your nearest authorized service dealer to replace the blade.

NOTE: Disconnect the hedge trimmer attachment from the powerhead before replacing the blade.

REMOVING BLADE

WARNING: Blades are sharp. When handling blade assembly, do not place your hand or fingers between blades or in any position where they could get pinched or cut.

1.Place hedge trimmer upside down on workbench and remove two (2) bottom plate screws (Fig. 8).

2.Remove bottom plate.

Bottom Plate Screw

Bottom Plate

Fig. 8

3.Align the cams (Fig. 9).

4.Remove the four (4) blade screws (Fig. 9).

Blade ScrewsCams

Fig. 9

5.Push the red end of the blade bar towards the cams. This will loosen the blade plate so that it can be removed easily from the cams (Fig. 10).

Fig. 10

6.Remove the blade by lifting and rotating it so that the blade yokes clears the lower cam first (Fig. 11).

45° ROTATE

Fig. 11

9