c. | If the dimension at the front | Deck Lift Spring inner bolt | ||
| of the mowing deck is | |||
|
|
| ||
| 4" lower than the dimension |
|
| |
| at the rear of the deck on |
|
| |
| each side of the mower, do |
|
| |
| not adjust. If not, you will |
|
| |
| need to adjust the Deck Lift |
|
| |
| Spring Assist (See Figure 5). |
|
| |
| You may also need to adjust |
|
| |
| the Deck Links (See Figure |
|
| |
| 5). | Figure. 5 | Deck Links | |
d. | Lower the mower deck to the | |||
|
| |||
cutting position. With a
wrench loosen the inner rear bolt on the Deck Lift Spring Assist. To adjust the deck up or down, use a wrench and with a few turns, adjust clockwise or counter clockwise the outer rear bolt of the Deck Lift Spring Assist. Repeat this procedure on the opposite side of the MMZ. Once the deck is adjusted, retighten bolts.
e.With the deck still in the cutting position, adjust the Deck Links. With a wrench loosen the top inner bolt of the Deck Link. To adjust the side of the deck up or down turn the top bolt clockwise or counter clockwise a few turns. Adjust both front and rear Deck links as necessary. Retighten bolts.
f.Raise the mowing deck to the transport position using the transport lever.
g.Use the transport lever to lower the mowing deck to the cut- ting position and repeat step “b.” above to make sure that the desired cutting height has been attained. If the dimen- sions are not correct, repeat steps “c.” through “f.” above.
5.Lubricate all fittings listed in the maintenance section.
C.Break-In And Operation
DANGER:
Reread the “When Mowing” Safety Precautions.
1.Start the Engine:
a.Open the fuel shutoff valve.
b.Sit on the Seat. Set the parking brake “On”.
c.Move the left and right steering levers to the neutral,
d.Turn the electric blade clutch switch “Off”.
11
