ZyXEL Communications 128MH user manual Load RAS code

Prestige 128MH PSTN Router/Hub

Menu 24.7 -- System Maintenance - Upload Firmware

1.Load RAS Code

2.Load ROM File

3.Load WAN Port 2 Modem Firmware

4.Load WAN Port 3 Modem Firmware

Enter Menu Selection Number:

Figure 13-10. Menu 24.7 - System Maintenance - Upload Firmaware

13.7.1 Load RAS code

Type [atur] and wait until your Prestige responds with an [OK] to begin uploading the new software (upload procedure varies depending on the type of software used to access your Prestige). You must use the XMODEM protocol to perform the upload. After uploading is successful, type [atgo] to start your Prestige. Below is an example of downloading RAS using

PCPLUS.

Menu 24.7.1 -- System Maintenance - Upload RAS Code

To load the RAS code, type "atur" while in debug mode and wait for "Starting XMODEM upload" before beginning to upload code.

Type "atgo" after code has successfully loaded to start RAS.

Proceeding with the upload will erase the current RAS code.

Do You Which To Proceed:(Y/N)

Figure 13-11. Menu 24.7.1 - Example of Uploading RAS Using PCPLUS

Chapter 13 System Maintenance 13-13